Search results for "Sequencing batch reactor"
showing 10 items of 28 documents
Relating ions concentration variations to conductivity variations in a sequencing batch reactor operated for enhanced biological phosphorus removal
2006
In this paper a deterministic relationship between ionic conductivity and phosphorus concentration variations in an enhanced biological phosphorus removal (EBPR) process is established. Conductivity shows a strong correlation with phosphorus in both anaerobic and aerobic stages, increasing or decreasing when phosphorus is released or taken up, respectively. Since the end of these processes can be detected by examining the conductivity profile in a cycle, useful information on the EBPR performance and stability is available. This information can be used for adjusting the length of the anaerobic and aerobic stages. Therefore, online process control based on inexpensive and easy to maintain se…
Using Unfold-PCA for batch-to-batch start-up process understanding and steady-state identification in a sequencing batch reactor
2007
In chemical and biochemical processes, steady-state models are widely used for process assessment, control and optimisation. In these models, parameter adjustment requires data collected under nearly steady-state conditions. Several approaches have been developed for steady-state identification (SSID) in continuous processes, but no attempt has been made to adapt them to the singularities of batch processes. The main aim of this paper is to propose an automated method based on batch-wise unfolding of the three-way batch process data followed by a principal component analysis (Unfold-PCA) in combination with the methodology of Brown and Rhinehart 2 for SSID. A second goal of this paper is to…
Process understanding of a wastewater batch reactor with block-wise PLS
2007
In this work a systematic methodology ‘block-wise PLS’ has been applied to thoroughly analyse data from a sequencing batch reactor (SBR) operated for biological phosphorus removal from wastewater. The aim of this study was to diagnose process variables (collected by the inexpensive and low-maintenance sensors installed in the SBR) likely related to the main key indicator of process performance: the phosphorus removal efficiency (PRE), determined off-line in the quality control laboratory. In this way, it is intended to aid the process operators in the detection of abnormal values of these critical variables which would indicate undesirable process performance, so that, they could act on the…
Effect of organic loading rate on the production of Polyhydroxyalkanoates from sewage sludge
2023
The aim of this work was to study the effect of organic loading rate on the production of Polyhydroxyalkanoates (PHA) from sewage sludge. Synthesis of PHA using sewage sludge as platform was achieved in this work. Three pilot-scale selection-sequencing batch reactors (S-SBR) were used for obtaining a culture able to accumulate PHA following a strategy of aerobic dynamic feeding (ADF) at different volumetric organic-loading-rate (vOLR): 1.3, 1.8 and 0.8 g COD L-1 d-1 for S-SBR 1, S-SBR 2 and S-SBR 3, respectively. Decreasing the vOLR enhanced the general performance of the process as for organic matter removal (from 99.2% ± 0.3% in S-SBR-3 to 92 ± 2 in S-SBR-2) while the opposite trend was r…
An extension of ASM2d including pH calculation
2003
This paper presents an extension of the Activated Sludge Model No. 2d (ASM2d) including a chemical model able to calculate the pH value in biological processes. The developed chemical model incorporates the complete set of chemical species affecting the pH value to ASM2d describing non-equilibrium biochemical processes. It considers the system formed by one aqueous phase, in which biochemical processes take place, and one gaseous phase, and is based on the assumptions of instantaneous chemical equilibrium under liquid phase and kinetically governed mass transport between the liquid and gas phase. The ASM2d enlargement comprises the addition of every component affecting the pH value and an i…
Evaluation of activated sludge model no.2 at high phosphorus concentrations
2001
This paper presents laboratory scale experimentation carried out to study enhanced biological phosphorus removal at high phosphorus concentrations in a sequencing batch reactor. Four series of data obtained in a sequencing batch reactor are examined in light of the Activated Sludge Model No. 2. This model was calibrated using data from the first and second series working at low phosphorus concentrations. The Activated Sludge Model No. 2 successfully characterised the enhanced biological phosphorus removal performance of the sequencing batch reactor at low phosphorus concentrations. The calibrated model was then used to adjust experimental results of the other series working at high phosphor…
Calcium phosphate precipitation in a SBR operated for EBPR: interactions with the biological process.
2008
The aim of this paper is to study the precipitation process in a sequencing batch reactor (SBR) operated for EBPR (enhanced biological phosphorus removal) and the possible effects of this phosphorus precipitation in the biological process. Four experiments were carried out under different influent calcium concentration. The experimental results and the equilibrium study, based on the Saturation Index calculation, confirm that the process controlling the calcium behaviour in a SBR operated for EBPR is the calcium phosphate precipitation. This precipitation takes place at two stages initially precipitation of the ACP and later crystallization of HAP. Also the accumulation of phosphorus precip…
Greenhouse gases from sequential batch membrane bioreactors: A pilot plant case study
2016
Abstract The paper reports the results of nitrous oxide (N 2 O) emissions from aerobic and anoxic tank of a Sequential Batch Membrane Bioreactor (SB-MBR) pilot plant. The influence of salinity variation on N 2 O emission was analyzed by gradually increasing the inlet salt concentration from 0 to 10 g NaCl L −1 . The observed results showed that the N 2 O concentration of the gaseous samples was strongly influenced by the salt concentration. This result was likely related to a worsening of the nitrification activity due to the effect of salinity on autotrophic bacteria. Dissolved oxygen concentration and salinity were found to be the key factors affecting N 2 O concentration in the gaseous s…
Aerobic granular sludge treating shipboard slop: Analysis of total petroleum hydrocarbons loading rates on performances and stability
2018
Abstract The work focuses on the feasibility of treating slop with aerobic granular sludge. For this purpose, a 3.5 L granular sequencing batch reactor was activated and it was monitored for 156 days. The experimental campaign was divided into two periods, named Period I (100 days) and Period II (56 days). Total Petroleum Hydrocarbon (TPH) concentration in the slop was, on average, equal to 6.8 ± 1.5 mg L−1 and 13 ± 1.5 mg L−1 in Period I and Period II respectively. The obtained results during the first experimental period indicated that about 80 days were required to reach steady state with mature granules, when TPHs removal efficiency was approximately 90%. The results indicated that both…
Achievement of partial nitrification under different carbon-to-nitrogen ratio and ammonia loading rate for the co-treatment of landfill leachate with…
2019
Abstract Partial nitrification (PN) is a technically and economically effective solution for the treatment of wastewater featuring low C/N ratio, allowing to achieve approximately 25% energy saving and 40% carbon source for denitrification. This study investigated the effect of different carbon to nitrogen ratio (C/N) and ammonia loading rate (ALR) on PN performances in a sequencing batch reactor (SBR) treating landfill leachate with municipal wastewater. The aim was to find an optimum range for C/N and ALR to maximize PN performances. Results demonstrated that a proper balancing between ALR and C/N is crucial to achieve high PN efficiency. The results highlighted the existence of an optimu…